'
TEL 262-654-3833 | Hours 8AM-5PM Central Standard Time M - F
Select Page
Sale!

Pentek EP-10 Carbon Block Cartridge (5 Micron)

Original price was: $ 14.80.Current price is: $ 8.70.

Pentek EP-10 Carbon Block Cartridge, 9.75 x 2.88 inch, 5 micron, bonded PAC, temperature 40-180°F, an ideal choice for a wide range of residential, food service, commercial and industrial applications.

Description

The Pentek EP Series Carbon Block Cartridge are manufactured using a process that yields a cartridge with a nominal 5-micron filtration rating and high dirt-holding capacity. A high porosity design helps prevent the cartridge from plugging before its adsorption capacity is exhausted, maximizing the utilization of the carbon while maintaining low pressure drop.

These Pentek EP-10 cartridges are protected by a uniquely formulated polyolefin bilaminate pre-filter, designed to significantly increase the useful life of the cartridge by trapping sediment that typically plugs carbon block cartridges. EP Series Cartridges make an ideal choice for a wide range of residential, food service, commercial and industrial applications.

Features

  • High dirt-holding capacity maximizes utilization of the carbon block*
  • Nominal 5-micron rating
  • Highly effective bad taste & odor and chlorine taste & odor reduction*

Specification

  • Pentek EP-10
  • Part: 155531-43
  • Rating (Normal): 5 micron
  • Diameter: 2.88 inch
  • Length: 9.75 inch
  • Initial delta P (PSI) @ Flow Rate (GPM): 1.7 psi @ 1.0 gpm (0.12 bar @ 3.8 Lpm)
  • Chlorine Taste & Odor Reduction @ Flow Rate (GPM): >6,000 gallons @ 1.0 gpm (>22,712 L @ 3.8 Lpm)
  • Filter Media – Bonded PAC
  • Endcaps – Polypropylene
  • Wrap – Polyolefin
  • Netting – Polyethylene
  • Gaskets – TPE/Santoprene
  • Temperature Rating –: 40-180°F (4.4-82.2°C)

>>>Pentek EP Series pdf<<<

*Based on manufacturer’s internal testing.

NOTES: Cartridges may contain a very small amount of carbon fines (very fine black powder). After installation, follow the instructions for flushing the cartridge to remove the fines before using the water. You should flush the tap at least 20 seconds prior to using water for drinking or cooking purposes. This is particularly important if the tap has not been used daily. Micron ratings based on 85% or greater removal of given particle size. Data obtained from actual particle counts using AC Fine Test Dust and Latex spheres. Estimated capacity using 2 ppm free available chlorine (FAC) at continuous flow with greater than 90% reduction. WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Additional information

Weight 1 lbs
Dimensions 9.75 × 2.88 × 2.88 in
Manufacturer Part Number

Reviews

There are no reviews yet.

Be the first to review “Pentek EP-10 Carbon Block Cartridge (5 Micron)”

Your email address will not be published. Required fields are marked *

Share This